| About |
|---|
| SABIC® LLDPE 324CE is a Linear Low Density Polyethylene natural resin typically used for wire and cable applications. SABIC® LLDPE 324CE contains a low level of antioxidants and does not contain any antiblock and/or slip agents. It also exhibits good Environmental Stress Crack Resistance (ESCR). Sufficient Cu-inhibitor should be added to meet specific ageing requirements. For jacketing applications, addition of Carbon Black or UV stabilizer is required. Applications Telecommunication and Power cable (LV, MV, HV) jacketing. Halogen-free flame retardant (HFFR) compounds. One-step or two-steps silane crosslinkable for cable insulation. This product is not intended for and must not be used in any pharmaceutical/medical applications.&& |
| Product Description | |
|---|---|
| Supplier | SABIC |
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Inoxidizability,Low density,High ESCR |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.924 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 3.6 | g/10min | ISO 1133 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | |||
| DSC | 123 | ℃ | Internal Method |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 8.5E+15 | ohms·cm | ASTM D257 |
| Dielectric strength | > 30 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 60 Hz | 2.20 | ASTM D150 | |
| Dissipation factor | |||
| 60 Hz | 5.0E-4 | ASTM D150 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 53 | ISO 868 | |
| tensile strength | ISO 527-2 | ||
| Yield, molding | 13.0 | MPa | |
| Fracture, molded | 22.0 | MPa | |
| Tensile strain | ISO 527-2 | ||
| Yield, molding | 21 | % | |
| Fracture, molded | 1900 | % | |
| Bending modulus | |||
| Compression Molding | 500 | MPa | ISO 178 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2000 V/sec |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |