| About |
|---|
| The pellet product is colourless and in the shape of a cylinder with good strength, good resistance to abrasion, excellent chemical stability, as well as fairly good heat-resistance. Scope of Application: BOPP film&& |
| Product Description | |
|---|---|
| Supplier | SINOPEC Shanghai |
| Generic | PP homopolymerization |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good wear resistance,Heat Resistance, Good,Homopolymer |
| Availabilitys | Asia Pacific |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 230℃，2.16kg | 9.0 to 15 | g/10min | Internal Method |
| Ash Content | < 0.030 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | > 31.4 | MPa | ASTM D638 |
| Bending modulus | > 1300 | MPa | Internal Method |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Notched impact strength of cantilever beam | |||
| 23℃ | > 16 | J/m | Internal Method |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | > 150 | ℃ | Internal Method |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Yellowness index | < 4.0 | YI | Internal Method |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Fish Eye | |||
| 400.0 µm | 16.0 to 35.0 | pcs/1520 cm² | |
| 800.0 µm | 4.00 to 8.00 | pcs/1520 cm² | |
| Isotacticity | > 96 | % |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |