| About |
|---|
| A soft, black, UV resistant thermoplastic vulcanizate (TPV) in the thermoplastic elastomer (TPE) family. This material combines good physical properties and chemical resistance for use in difficult injection molding applications. This grade of Santoprene TPV is shear-dependent and can be processed on conventional thermoplastics equipment for injection molding. It is polyolefin based and recyclable within the manufacturing stream.&& |
| Product Description | |
|---|---|
| Supplier | Celanese |
| Material Status | Commercial: Active |
| Features | Renewable resources,Solvent resistance,Ozone resistance,Excellent Processability,Good surface appearance,Fatigue resistance,HB,Weather resistance is good,Good Dimensional Stability,High liquidity |
| Availabilitys | Asia Pacific,North America,Latin America,Africa & Middle East ,Europe |
| Process Methods | Multiple injection molding,Injection Molding |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Tensile Strength | |||
| 100% elongation, vertical perpendicular | 1.8 | MPa | ISO 527-2 |
| Vertical vertical | 4.39 | MPa | ISO 527-2 |
| Elongation at Break | 465 | % | ISO 527-1,2 |
| Shore hardness | 56 | Shore A | ISO 868 |
| 23℃，24 h | 31 | % | ISO 815 |
| 70 ℃，24 h | 42 | % | ISO 815 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 915 | kg/m³ | ISO 1183 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Brittle Temperature | -60 | ℃ | ASTM D746 |
| Low temperature brittleness | -60 | ℃ | ISO 812 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame Class Rating | |||
| 1.1 mm | HB | calss | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| Injection Molding | Nominal value | Unit | Test method |
| Drying Temperature | 82 | ℃ | |
| Drying Time | 3 | hr | |
| Maximum Moisture Content | 0.08 | % | |
| Maximum regrind level | 20 | % | |
| Melt Temperature | 215 | ℃ | |
| Mold Temperature | 10-52 | ℃ | |
| Injection speed | 快速 | ||
| Vent Depth | 25 | μm | |
| Back Pressure | 0.345-0.689 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type 1 |
| 3. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |