| About |
|---|
| A soft, black, UV resistant thermoplastic vulcanizate (TPV) in the thermoplastic elastomer (TPE) family. This material combines good physical properties and chemical resistance, and is designed for thin wall or complex profile extrusion applications. This grade of Santoprene TPV is shear-dependent and can be processed on conventional thermoplastics equipment for extrusion. It is polyolefin based and recyclable within the manufacturing stream.&& |
| Product Description | |
|---|---|
| Supplier | Celanese |
| Material Status | Commercial: Active |
| Features | Solvent resistance,Renewable resources,Good Dimensional Stability,Ozone resistance,Good melt strength,Weather resistance is good |
| Availabilitys | Latin America,Europe,North America,Africa & Middle East ,Asia Pacific |
| Process Methods | Extrusion,Profile extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.97 | g/cm³ | ASTM D792 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Brittle Temperature | -60 | ℃ | ASTM D746 |
| Coeff. of linear thermal expansion |
| ELECTRICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Insulation Strength | |||
| 2.03mm | 25 | KV/mm | ASTM D149 |
| Dielectric Constant | |||
| 23℃ | 2.70 | 1 kHz | ASTM D150 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | 62 | ASTM D2240 | |
| Tensile Strength | |||
| 23℃ | 5.00 | MPa | ASTM D638 |
| Tensile Strain | |||
| Broken BRK, 23 ℃ | 440 | % | ASTM D638 |
| Tear strength | |||
| TD | 36 | KN/m |
| Process Conditions | |||
|---|---|---|---|
| Extrusion Molded | Nominal value | Unit | Test method |
| Injection Molding | Nominal value | Unit | Test method |
| Drying Temperature | 80 | ℃ | |
| Drying Time | 3 | hr | |
| Die Temperature | 205 | ℃ | |
| Drying Temperature | 82.2 -82.2 | ℃ | |
| Drying Time | 3 | hr | |
| Maximum Moisture Content | 0.08 | % | |
| Rear Temperature Zone 1 | 182-182 | ℃ | |
| Middle Temperature Zone 2 | 188-188 | ℃ | |
| Front Temperature Zone 3 | 193-193 | ℃ | |
| Die Temperature | 204-221 | ℃ | |
| Mold Temperature | 10-51.7 | ℃ | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Die C |
| 3. Method Bb, Angle (Nicked) |
| 4. Type 1 |
| 5. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |