| About |
|---|
| A soft, black thermoplastic vulcanizate (TPV) in the thermoplastic elastomer (TPE) family. This material is specially formulated to bond to sulfur or peroxide-cured thermoset EPDM rubber for corner molding, end caps and special fixation applications, and for COF enhancement. This grade of Santoprene TPV is shear-dependent and can be processed on conventional thermoplastics equipment for injection molding. It is polyolefin based and recyclable within the manufacturing stream.&& |
| Product Description | |
|---|---|
| Supplier | Celanese |
| Material Status | Commercial: Active |
| Features | Renewable resources,Weather resistance is good,Agglomerability,Low coefficient of friction,Ozone resistance |
| Availabilitys | Europe,Africa & Middle East ,Asia Pacific,North America,Latin America |
| Process Methods | Injection Molding,Multiple injection molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.918 | g/cm³ | ASTM D792 |
| Density | 0.920 | g/cm³ | ISO 1183 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| TD, fracture, 23 ℃ | 6.50 | MPa | ASTM D412 |
| TD, fracture, 23 ℃ | 6.50 | MPa | ISO 37 |
| TD, 100% strain, 23 ℃ | 2.60 | MPa | ISO 37 |
| TD, 100% strain, 23 ℃ | 2.60 | MPa | ASTM D412 |
| Tensile strain | |||
| TD, fracture, 23 ℃ | 470 | % | ASTM D412 |
| TD, fracture, 23 ℃ | 470 | % | ISO 37 |
| Compression deformation | |||
| 70℃，22 hr | 44 | % | ASTM D395B |
| 70℃，22 hr | 44 | % | ISO 815 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds, 23 ℃ | 74 | ISO 868 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type 1 |
| 3. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |