| About |
|---|
| A soft, black, UV resistant thermoplastic vulcanizate (TPV) in the thermoplastic elastomer (TPE) family. This material is designed for gap filler applications requiring scratch resistance and good appearance. This grade of Santoprene TPV is shear-dependent and can be processed on conventional thermoplastics equipment for injection molding. It is polyolefin based and recyclable within the manufacturing stream.&& |
| Product Description | |
|---|---|
| Supplier | Celanese |
| Material Status | Commercial: Active |
| Features | Renewable resources |
| Availabilitys | North America,Latin America,Europe,Africa & Middle East ,Asia Pacific |
| Process Methods | Multiple injection molding,Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.928 | g/cm³ | ASTM D792 |
| Density | 0.930 | g/cm³ | ISO 1183 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| TD, fracture, 23 ℃ | 6.20 | MPa | ISO 37 |
| TD, fracture, 23 ℃ | 6.20 | MPa | ASTM D412 |
| TD, 100% strain, 23 ℃ | 2.60 | MPa | ISO 37 |
| TD, 100% strain, 23 ℃ | 2.60 | MPa | ASTM D412 |
| Tensile strain | |||
| TD, fracture, 23 ℃ | 480 | % | ISO 37 |
| TD, fracture, 23 ℃ | 480 | % | ASTM D412 |
| Compression deformation | |||
| 70℃，22 hr | 40 | % | ISO 815 |
| 70℃，22 hr | 40 | % | ASTM D395B |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds, 23 ℃ | 70 | ISO 868 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type 1 |
| 3. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |