| About |
|---|
| A hard, colorable, UV resistant thermoplastic vulcanizate (TPV) in the thermoplastic elastomer (TPE) family. This material is designed for automotive interior applications requiring low fogging and good appearance. This grade of Santoprene TPV is shear-dependent and can be processed on conventional thermoplastics equipment for injection molding. It is polyolefin based and recyclable within the manufacturing stream.&& |
| Product Description | |
|---|---|
| Supplier | Celanese |
| Material Status | Commercial: Active |
| Features | Renewable resources,Excellent Processability,Ozone resistance,Good surface appearance,High liquidity,Weather resistance is good,Good coloring |
| Availabilitys | Africa & Middle East ,Europe,Asia Pacific,Latin America,North America |
| Process Methods | Multiple injection molding,Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.92 | g/cm³ | ASTM D792 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -59 | ℃ | ASTM D746 |
| Linear coefficient of thermal expansion |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Insulation strength | |||
| 2.03mm | 31 | KV/mm | ASTM D149 |
| Dielectric constant | |||
| 23℃ | 2.30 | 1 kHz | ASTM D150 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| Extreme oxygen index | 26 | % | ASTM D2863 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shaw A15s | 84 | ASTM D2240 | |
| tensile strength | |||
| 23℃ | 9.00 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 500 | % | ASTM D638 |
| tear strength | |||
| TD | 25 | KN/m |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion molding conditions | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 3 | Hr | |
| Injection temperature | |||
| Rear barrel temperature | 180-195 | °C | |
| Central temperature of the barrel | 185-200 | °C | |
| Barrel front temperature | 190-200 | °C | |
| Die temperature | 190-210 | °C | |
| Mold temperature | 25-50 | °C | |
| Die temperature | 185-221 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |