| About |
|---|
| SCLAIR® 2610CC is a High Density Polyethylene material. It is available in North America for injection molding. Important attributes of SCLAIR® 2610CC are: Antioxidant Butene Comonomer Fast Molding Cycle Food Contact Acceptable Good Aesthetics Typical applications include: Caps/Lids/Closures Consumer Goods Containers Food Contact Applications Household Applications&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Negative |
| Features | Excellent Processability,High elastic,Quick molding cycle,Food contact compliance,Inoxidizability,Good sensory characteristics.,Butylene copolymer,High ESCR |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.946 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 18 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 100% non-ionic detergent, F50 | < 19.0 | hr | ASTM D1693B |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 120 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 61 | ASTM D2240 | |
| tensile strength | |||
| yield | 22.0 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 170 | % | ASTM D638 |
| Bending modulus | 1160 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |