SEALUTION™ 210 Peel Polymer

About
SEALUTION™ 210 Peel Polymer is a peelable sealant that gives a peelable seal to itself, polypropylene, and polyethylene. It is formulated for high clarity & low haze, which gives improved shelf appeal of finished films. Main Characteristics: Pellets Blown film Peelable sealant to itself, PP, and PE Good optics (high clarity, low haze) Complies with: Europe Commission Regulation (EU) No 10/2011 U.S. FDA Consult the regulations for complete details.&&

About

SEALUTION™ 210 Peel Polymer is a peelable sealant that gives a peelable seal to itself, polypropylene, and polyethylene. It is formulated for high clarity & low haze, which gives improved shelf appeal of finished films. Main Characteristics: Pellets Blown film Peelable sealant to itself, PP, and PE Good optics (high clarity, low haze) Complies with: Europe Commission Regulation (EU) No 10/2011 U.S. FDA Consult the regulations for complete details.&&

Product Description
Supplier	DOW
Generic	POP
Material Status	Commercial: Active
Availabilitys	North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ASTM D792
Melt Flow Rate			ASTM D1238
190℃，2.16kg	1.5	g/10min	ASTM D1238
230℃，2.16kg	3.5	g/10min	ASTM D1238

film	Nominal value	Unit	Test method
film thickness
test	51	µm
Initial sealing temperature
51 µ m, blow molded film	105	℃	Internal Method
Strippable range	105 to 210	℃	Internal Method

optical performance	Nominal value	Unit	Test method
Haze
50.8 µm	< 10	%	ASTM D1003

Notes
1. Typical properties: these are not to be construed as specifications.
2. Temperatures at which 0.8 lb/in (2 N/15 mm) heat seal strength is achieved. Heat Seal Strengths, Topwave HT Tester 0.5 s dwell, 72.5 psi (5 bar) pressure, pull speed 3.9 in/sec (100 mm/sec).
3. Peelable range of 2.3-3.4 lb/in (6-9 N/15 mm) for this particular structure, seal to itself. Peelable range of 1.9-2.7 lb/in (5-7 N/15 mm) for this particular structure, seal to PP sheet. Heat Seal Strengths, Topwave HT Tester 0.5 s dwell time, 72.5 psi (5 bar) pressure, pull speed 3.9 in/sec (100 mm/sec).
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.