| About |
|---|
| Sequel 2326 thermoplastic polyolefin material is designed for molded-in-color automotive interior applications that require energy-management properties. This product is typically supplied in natural or an OEM matched interior color w ith UV protection.&& |
| Product Description | |
|---|---|
| Supplier | LyondellBasell |
| Generic | Polyolefin Elastomer |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Ductility,low-temperature impact resistance,Good coloring |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.960 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 15 | g/10min | ISO 1133 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, 4 mm | 16.0 | MPa | ISO 527-2/50 |
| Bending modulus | |||
| 4 mm | 1100 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ISO 180 | ||
| -40℃ | 6.0 | kJ/m² | ISO 180 |
| 23℃ | No Break | ISO 180 | |
| Dart impact equipped with measuring instruments | ASTM D3763 | ||
| -30℃ | 24.0 | J | ASTM D3763 |
| 23℃ | 18.0 | J | ASTM D3763 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 54.0 | ℃ | ISO 75-2/A |
| 0.45 MPa, unannealed | 75.0 | ℃ | ISO 75-2/B |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 0.079 in/min |
| 3. 22.0 ft/sec |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |