| About |
|---|
| SlLVER® PVC for Injection Molding conforming ROHS and DEHP is applied to power connector plugs and other injection molding parts for electrical appliance. In addition, the custom—made products should be developed by buyers‘ requirements in order to meet special usage.&& |
| Product Description | |
|---|---|
| Supplier | Silver Age |
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Features | V-0 |
| Availabilitys | Asia Pacific |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.45 | g/cm³ | |
| Melt Flow Rate | |||
| 200℃，5.0kg | 6.0 | g/10min | |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -20.0 | ℃ |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 1.60 mm | V-0 | UL 94 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Volatile loss | < 20.0 | g/m² |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 95 | ||
| tensile strength | 16.0 | MPa | |
| Tensile strain | |||
| fracture | 120 | % |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. after aging |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |