| About |
|---|
| SlLVER® SA—3000 elastomer is designed to over-mold and co-extrude with rigid engineering resins (such as PP, ABS, PC, PA and so on) to provide a soft touch grip feature without the use of adhesives or additional assembly steps. The over-molding products are of good handle, antislip, high impact strength and coloration. SA—3000 Elastomer (over-molding and co-extruding grade ) Characteristics: over-mold and co-extrude with rigid engineering resins (such as PP, ABS, PC, PA and so on) Applications: tool handle and coat, luggage handle, shaver handle toothbrush handle, frog shoe and so on&& |
| Product Description | |
|---|---|
| Supplier | Silver Age |
| Generic | TPE |
| Material Status | Commercial: Active |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.898 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 230℃，5.0kg | 5.0 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 3 seconds | 65 | ASTM D2240 | |
| tensile strength | 5.00 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | > 550 | % | ASTM D638 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 180 to 220 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 20 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |