| About |
|---|
| Sinvicomp SIZ5009 is a Flexible Polyvinyl Chloride material. It is available in Asia Pacific for extrusion. Primary attribute of Sinvicomp SIZ5009: RoHS Compliant. Typical application of Sinvicomp SIZ5009: Wire & Cable&& |
| Product Description | |
|---|---|
| Supplier | Teknor Apex |
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Availabilitys | Asia Pacific |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.43 | g/cm³ | ASTM D792 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Changes in mechanical properties after hot air aging test, 168 hours | IEC 811-1-2 | ||
| The rate of change in tensile strength | 10 | % | IEC 811-1-2 |
| Change in tensile elongation | 10 | % | IEC 811-1-2 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | |||
| 23℃ | 2.0E+14 | ohms·cm | BS 2782 230A |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Loss of Mass | |||
| Oven Ageing Condition @ 80 ± 2℃ for 7 days | 0.500 | mg/cm² | BS 2782 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 90 | ASTM D2240 | |
| tensile strength | 18.0 | MPa | IEC 811-1-1 |
| Tensile strain | |||
| fracture | 250 | % | IEC 811-1-1 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. @ 23°C |
| 3. @ 80 ± 2°C |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |