| About |
|---|
| Siveras™ L304T40 is a Liquid Crystal Polymer (LCP) product filled with 40% glassmineral. It is available in Asia Pacific, Europe, or North America. Applications of Siveras™ L304T40 include electrical/electronic applications and appliances. Characteristics include: Flame Rated Warp Resistant&& |
| Product Description | |
|---|---|
| Supplier | Toray |
| Generic | 液态聚合物 |
| Material Status | Commercial: Active |
| Features | Low warping,V-0 |
| Availabilitys | Asia Pacific,Europe,North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.72 | g/cm³ | ASTM D792 |
| Shrinkage rate | Internal Method | ||
| TD：1.00 mm | 0.52 | % | Internal Method |
| MD：1.0 mm | 0.020 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 130 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 2.8 | % | ASTM D638 |
| Bending modulus | 13200 | MPa | ASTM D790 |
| bending strength | 160 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 65 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 270 | ℃ | ASTM D648 |
| Linear coefficient of thermal expansion | |||
| MD | 8.0E-6 to 1.9E-5 | 1/℃ | ASTM D696 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| 0.38 mm | V-0 | UL 94 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 80x80x1mm |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |