| About |
|---|
| Product Description | |
|---|---|
| Supplier | SUQING |
| Generic | Polyetherimide |
| Material Status | Commercial: Active |
| Features | Good Dimensional Stability,Antistatic property,Good flexibility,High strength |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.31 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| flow | 0.2-0.4 | ASTM D955 | |
| cross-flow | 0.3-0.6 | ASTM D955 | |
| Water absorption rate | 0.4 | % | ASTM D570 |
| Melt Flow Rate | |||
| 337℃，6.6kg | 8 | g/10min | ASTM D1238 |
| Filling content | |||
| 800℃/2h | 20 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 50mm/min | 220 | MPa | ASTM D638 |
| Tensile strain | |||
| 50mm/min | 6.0 | % | ASTM D638 |
| bending strength | |||
| 3mm/min | 225 | MPa | ASTM D790 |
| Bending modulus | |||
| 3mm/min | 13000 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 70 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.82MPa | 210 | ℃ | ASTM D648 |
| melting point | 340 | ℃ | ASTM D2133 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 1/16 inch | V-0 | UL 94 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | 4.0E+8 | ohm | ASTM D257 |
| Process Conditions | |||
|---|---|---|---|
| injection molding | Nominal value | Unit | Test method |
| drying temperature | 160-190 | ℃ | |
| Drying time | 3-5 | hrs | |
| Injection mold temperature | 120-170 | ℃ | |
| Injection screw temperature | 330-360 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |