| About |
|---|
| Product Description | |
|---|---|
| Supplier | SUQING |
| Material Status | Commercial: Active |
| Features | High modulus,High strength |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.65 | ASTM D792 | |
| Shrinkage rate | |||
| MD | 0.1-0.2 | % | ASTM D955 |
| TD | 0.1-0.2 | % | ASTM D955 |
| Water absorption rate | 0.04 | % | ASTM D570 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| 50mm/min | 145 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 50mm/min | 1.1 | % | ASTM D638 |
| bending strength | |||
| 3mm/min | 200 | MPa | ASTM D790 |
| Bending modulus | |||
| 3mm/min | 12500 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 78 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| melting point | 284 | ℃ | ASTM D2133 |
| Hot deformation temperature | |||
| 1.82Mpa | 255 | ℃ | ASTM D648 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | V-0 | UL 94 |
| Process Conditions | |||
|---|---|---|---|
| Processing temperature | Nominal value | Unit | Test method |
| drying temperature | 130-150 | ℃ | |
| Drying time | 4-6 | hr | |
| Injection mold temperature | 110-140 | ℃ | |
| Injection screw temperature | 265-295 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |