| About |
|---|
| 40% Glass Reinforced, Heat Stabilized, Lubricated&& |
| Product Description | |
|---|---|
| Supplier | DSM |
| Generic | PA 46 |
| Material Status | Commercial: Active |
| Features | Lubricating,Heat Stabilized |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Shrinkage rate | |||
| MD | 0.5 | ISO 294-4 | |
| TD | 1.1 | ISO 294-4 | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | |||
| – | 13000 | MPa | ISO 527-2 |
| 120℃ | 6900 | MPa | ISO 527-2 |
| 160℃ | 6100 | MPa | ISO 527-2 |
| 180℃ | 5700 | MPa | ISO 527-2 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 295 | ℃ | ISO 11357-3 |
| Hot deformation temperature | |||
| 1.80 MPa | 290 | ℃ | ISO 75-1 |
| 0.45 MPa | 290 | ℃ | ISO 75-1 |
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| Injection speed | Nominal value | Unit | Test method |
| drying temperature | 80 | °C | |
| Drying time | 4.0 to 8.0 | hr | |
| Temperature at the rear of the barrel | 280 to 320 | °C | |
| Temperature in the middle of the barrel | 300 to 320 | °C | |
| Front temperature of material barrel | 300 to 320 | °C | |
| Nozzle temperature | 300 to 320 | °C | |
| Processing (melt) temperature | 305 to 320 | °C | |
| Mold temperature | 80 to 120 | °C | |
| Back pressure | 2.00 to 10.0 | MPa | |
| Screw compression ratio | 2.5:1.0 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 10°C/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |