| About |
|---|
| Polystyrene impact modified, very glossy surface, for injection moulding.&& |
| Product Description | |
|---|---|
| Generic | PS (HIPS) |
| Material Status | Commercial: Active |
| Features | Good surface appearance,High impact resistance |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.04 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 0.40-0.70 | % | ASTM D995 |
| Water absorption rate | |||
| 23℃，24hr | 0.10 | % | ASTM D570 |
| Melt Flow Rate | |||
| 220℃，5.0kg | 6.50 | g/10min | ASTM D1238 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 81.10 | ℃ | ASTM D648 |
| Vicat Softening Temp | |||
| 85 | ℃ | ASTM D1525 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 1.59 mm | HB | UL-94 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 55 | J/m | ASTM D256 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| L | 80 | L | ASTM D785 |
| tensile strength | |||
| 23℃ | 25 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, 23 ℃ | 25 | % | ASTM D638 |
| Tensile modulus | |||
| 23℃ | 2000 | MPa | ASTM D638 |
| bending strength | |||
| 23℃ | 46 | MPa | ASTM D790 |
| Bending modulus | |||
| 23℃ | 2000 | MPa | ASTM D790 |
| Tensile fracture strength | 23 | MPa | ASTM D-638 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 0.20 in/min |
| 3. 0.051 in/min |
| 4. Rate B (120°C/h), Loading 2 (50 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |