Sumiflex® K K58DL13

About
Sumiflex® K K58DL13 is a Polyvinyl Chloride Elastomer (PVC Elastomer) material. It is available in Asia Pacific for injection molding. Primary attribute of Sumiflex® K K58DL13: Low Gloss. Typical application of Sumiflex® K K58DL13: Automotive&&

Product Description
Supplier	Mitsubishi
Generic	PVC elastomer
Material Status	Commercial: Active
Features	Low Gloss
Availabilitys	Asia Pacific
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.21	g/cm³	JIS K7112

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
10 seconds	49		JIS K6253

elastic body	Nominal value	Unit	Test method
tensile strength
fracture	5.10	MPa	JIS K6723
100% strain	2.70	MPa	JIS K6723
Tensile strain
fracture	250	%	JIS K6723

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.