| About |
|---|
| SUMIKON PM-6630 Type Black is a Short Glass fiber & Mineral molding compound based on Phenolic Novolac polymer. It is supplied in the form of Granular/Molding Powder for Molding. This grade is official registered UL with V-0 (t=3.0).&& |
| Product Description | |
|---|---|
| Supplier | SBHPP |
| Generic | 酚醛树脂 |
| Material Status | Commercial: Active |
| Features | V-0 |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.80 | g/cm³ | ISO 1183 |
| Apparent density | 0.80 | g/cm³ | ISO 60 |
| Shrinkage rate | 0.15 | % | ISO 2577 |
| Water absorption rate | |||
| 23℃，24hr | 0.050 | % | ISO 62 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| Compression Molding | 4.5 | kJ/m² | ISO 180 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | ISO 75-2/A | ||
| 1.8 MPa, unannealed | 200 | ℃ | |
| 1.8 MPa, annealed | > 282 | ℃ | |
| Linear coefficient of thermal expansion | |||
| MD | 1.4E-5 | 1/℃ | ASTM E831 |
| Thermal conductivity coefficient | 0.60 | W/m/K | ASTM C518 |
| Relative temperature index | 150 | ℃ | UL 746 |
| Electrical performance | 150 | ℃ | UL 746 |
| Impact mechanical performance | 150 | ℃ | UL 746 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 12 | kV/mm | ASTM D149 |
| Arc resistance | 135 | sec | ASTM D495 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | UL 94 | ||
| 1.60 mm | V-0 | ||
| 3.20 mm | V-0 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| E-level | 100 | ISO 2039-2 | |
| tensile strength | |||
| Fracture, molded | 90.0 | MPa | ISO 527-2 |
| Bending modulus | |||
| Compression Molding | 19000 | MPa | ISO 178 |
| bending strength | |||
| Compression Molding | 185 | MPa | ISO 178 |
| compressive strength | 360 | MPa | ISO 604 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. After boiling |
| 3. As molded |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |