| About |
|---|
| LLC6-500 is a copolymer certified prime resin designed for High-Flow Injection Molding of thin-walled, high quality applications. LLC6-500 features easy processability over a wide range of molding conditions, high gloss surface, good rigidity, fast cycle times, low temperature toughness and warpage free moldings. Suggested processing temperature is 170 to 210°C, with the mold at 20 to 40°C. LLC6-500 complies with FDA regulation 21CFR 177.1520 (c) 3.1a and most international regulations concerning the use of Polyethylene in contact with food articles.&& |
| Product Description | |
|---|---|
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Low warping,Excellent Processability,Good surface appearance,High liquidity,Quick molding cycle,Food contact compliance,Low density,Copolymer,Low temperature toughness |
| Availabilitys | North America |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.926 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 50 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 50 ℃，F50 | 5.00 | hr | ASTM D1693 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 15.2 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 90 | % | ASTM D638 |
| Bending modulus | |||
| 1% secant | 448 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 440 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -65.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 91.0 | ℃ | ASTM D1525 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | 170 to 210 | °C | |
| Mold temperature | 20 to 40 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 20 in/min |
| 3. 0,051 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |