| About |
|---|
| TECHNO ALPHALOY MPC6801 is a Polycarbonate + ABS (PC+ABS) product. It is available in Asia Pacific, Europe, Latin America, or North America. Primary characteristic: heat resistant.&& |
| Product Description | |
|---|---|
| Supplier | Techno |
| Generic | PC+ABS |
| Material Status | Commercial: Active |
| Features | Heat Resistance, Good |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.14 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 240℃，10.0kg | 20 | g/10min | ISO 1133 |
| Shrinkage rate | 0.50 to 0.80 | % | ISO 294-4 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | 62 | kJ/m² | ISO 179 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 109 | ℃ | ISO 75-2/B |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 117 | ISO 2039-2 | |
| tensile strength | |||
| yield | 59.0 | MPa | ISO 527-2 |
| Bending modulus | 2290 | MPa | ISO 178 |
| bending strength | 87.0 | MPa | ISO 178 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 100 to 110 | °C | |
| Drying time | 2.0 to 5.0 | hr | |
| Barrel rear temperature | 220 to 270 | °C | |
| Barrel middle temperature | 220 to 270 | °C | |
| Barrel front temperature | 220 to 270 | °C | |
| Mold temperature | 50 to 100 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |