| About |
|---|
| TechnoFin PP EPDM T 15 2 UV G 12 (74915) is a Polypropylene + EPDM Rubber (PP+EPDM) material. It is available in Asia Pacific, Europe, or North America for injection molding. Primary attribute of TechnoFin PP EPDM T 15 2 UV G 12 (74915): UV Stabilized.&& |
| Product Description | |
|---|---|
| Generic | PP+EPDM |
| Material Status | Commercial: Active |
| Features | Weather resistance is good |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.01 | g/cm³ | ISO 1183 |
| Melt Volume Rate | |||
| 230℃，2.16 kg | 12.0 | cm³/10min | ISO 1133 |
| Ash Content | |||
| 625℃ | 15 | % | ISO 3451 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 1400 | MPa | ISO 527-2 |
| tensile strength | |||
| yield | 21.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| yield | 9.0 | % | ISO 527-2 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | |||
| 23℃ | 40 | kJ/m² | ISO 179/1eA |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Drying time | 2.0 to 4.0 | hr | |
| Processing (melt) temperature | 220 to 280 | °C | |
| Mold temperature | 30 to 60 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |