TECHNYL® A 118L V50 BLACK 2428

About
TECHNYL® A 118L V50 Black 2428 is a polyamide 6.6, reinforced with 50% of glass fiber, heat stabilized, UV stabilized and modified viscosity, for injection moulding. This grade offers excellent combination between thermal and mechanical properties under external environment (UV radiation). It has a high fluency that permits the injection mould of big dimension or complex geometric structures, an excellent dimensional stability and chemical stability. ,,&&

About

TECHNYL® A 118L V50 Black 2428 is a polyamide 6.6, reinforced with 50% of glass fiber, heat stabilized, UV stabilized and modified viscosity, for injection moulding. This grade offers excellent combination between thermal and mechanical properties under external environment (UV radiation). It has a high fluency that permits the injection mould of big dimension or complex geometric structures, an excellent dimensional stability and chemical stability. ,,&&

Product Description
Supplier	DOMO
Generic	PA66
Material Status	Commercial: Active
Features	Good surface appearance,Weather resistance is good,HB,Heat Stabilized
Availabilitys	Latin America
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.57	g/cm³	ISO 1183/A
Water absorption rate
23℃，24hr	0.60	%	ISO 62

MECHANICAL	Nominal value	Unit	Test method
tensile strength
Fracture, 23 ℃	220	MPa	ISO 527-2/1A
Tensile strain
Fracture, 23 ℃	1.8	%	ISO 527-2
Bending modulus
23℃	16800	MPa	ISO 178
bending strength
23℃	355	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Charpy Unnotch Impact strength
23℃	60	kJ/m²	ISO 179/1eU
Impact strength of cantilever beam notch
23℃	14	kJ/m²	ISO 180

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	250	℃	ISO 75-2/Af

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
1.60 mm	HB		UL 94

Process Conditions
Injection	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	270 to 280	°C
Temperature in the middle of the barrel	280 to 290	°C
Front temperature of material barrel	280 to 300	°C
Mold temperature	70 to 100	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.