TECHNYL® A 218 MV30 BLACK

About
TECHNYL® A 218 MV30 Black is a polyamide 66, reinforced with 30% of mixed glass fibre and mineral filler, heat stabilized, for injection moulding. This grade offers an excellent combination between thermal and mechanical properties as well as a low warpage of molded parts.&&

Product Description
Supplier	DOMO
Generic	PA66
Material Status	Commercial: Negative
Features	Heat Stabilized,Low warping
Availabilitys	Asia Pacific
Process Methods	Injection Molding

Technical Data

Process Conditions
Injection	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	270 to 280	°C
Temperature in the middle of the barrel	275 to 285	°C
Front temperature of material barrel	280 to 290	°C
Mold temperature	70 to 100	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.