TECHNYL® A 218W V33 NATURAL T

About
TECHNYL® A 218W V33 Natural T is a polyamide 66, reinforced with 30% of glass fibre, heat stabilized, for injection moulding. The product is particularly recommended for the moulding of parts where some translucency is required, as well as surface aesthetics is important.&&

Product Description
Supplier	DOMO
Generic	PA66
Material Status	Commercial: Active
Features	Good surface appearance,Heat Stabilized
Availabilitys	North America
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.40	g/cm³	ISO 1183/A

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus
23℃	10200	MPa	ISO 527-2/1A
tensile strength
Fracture, 23 ℃	190	MPa	ISO 527-2/1A
Tensile strain
Fracture, 23 ℃	3.8	%	ISO 527-2
Bending modulus
23℃	8950	MPa	ISO 178
bending strength
23℃	294	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Charpy Notched Impact Strength
23℃	11	kJ/m²	ISO 179/1eA
Charpy Unnotch Impact strength
23℃	91	kJ/m²	ISO 179/1eU
Impact strength of cantilever beam notch
23℃	11	kJ/m²	ISO 180

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	247	℃	ISO 75-2/Af
0.45 MPa, unannealed	263	℃	ISO 75-2/Bf
Melting temperature	263	℃	ISO 11357-3

Process Conditions
Injection	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	270 to 280	°C
Temperature in the middle of the barrel	275 to 285	°C
Front temperature of material barrel	280 to 290	°C
Mold temperature	70 to 100	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.