TECHNYL® A 222F NATURAL FA

About
TECHNYL® A 222F Natural FA is an unfilled polyamide 66, heat stabilized, medium viscosity, for injection moulding, fast crystallization, for short cycles. This grade offers a good combination between primary properties of the unreinforced polyamide 66 and processing properties leading to increased productivity. These performances are associated with excellent dimensional stability and good rigidity of moulded parts. It is designed to be used in food contact applications.&&

About

TECHNYL® A 222F Natural FA is an unfilled polyamide 66, heat stabilized, medium viscosity, for injection moulding, fast crystallization, for short cycles. This grade offers a good combination between primary properties of the unreinforced polyamide 66 and processing properties leading to increased productivity. These performances are associated with excellent dimensional stability and good rigidity of moulded parts. It is designed to be used in food contact applications.&&

Product Description
Supplier	DOMO
Generic	PA66
Material Status	Commercial: Negative
Features	Good liquidity,Food contact compliance,Heat Stabilized,Quick molding cycle
Availabilitys	Europe,Africa & Middle East
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.14	g/cm³	ISO 1183/A
Water absorption rate
23℃，24hr	1.2	%	ISO 62

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus
23℃	4000	MPa	ISO 527-2/1A
tensile strength			ISO 527-2/1A
Yield, 23 ℃	95.0	MPa	ISO 527-2/1A
Fracture, 23 ℃	95.0	MPa	ISO 527-2/1A
Tensile strain
Fracture, 23 ℃	9.0	%	ISO 527-2

IMPACT	Nominal value	Unit	Test method
Charpy Notched Impact Strength
23℃	4.1	kJ/m²	ISO 179/1eA

THERMAL	Nominal value	Unit	Test method
Melting temperature	261	℃	ISO 11357-3

Process Conditions
Injection	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	265 to 275	°C
Temperature in the middle of the barrel	270 to 280	°C
Front temperature of material barrel	280 to 285	°C
Mold temperature	60 to 80	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.