| About |
|---|
| TECHNYL® eXten D 218 V30 Black is a polyamide 6.10, reinforced with 30% of glass fibre, heat stabilized, for injection moulding. This grade offers excellent chemical resistance, low water absorption, very good mechanical properties and moldability. It is a partially bio-sourced material.&& |
| Product Description | |
|---|---|
| Supplier | DOMO |
| Generic | PA610 |
| Material Status | Commercial: Active |
| Features | Heat Stabilized,Low or no water absorption,Solvent resistance,Excellent Processability |
| Availabilitys | North America,Asia Pacific,Latin America,Europe,Africa & Middle East |
| Process Methods | Injection Molding |
| Technical Data |
|---|
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| drying temperature | 80.0 | °C | |
| Recommended maximum moisture content | 0.20 | % | |
| Temperature at the rear of the barrel | 225 to 230 | °C | |
| Temperature in the middle of the barrel | 230 to 240 | °C | |
| Front temperature of material barrel | 240 to 250 | °C | |
| Mold temperature | 80.0 to 100 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |