| About |
|---|
| TECHNYL eXten® D 238 V30 Black is a polyamide 6.10, reinforced with 30% of glass fibre, heat stabilized, impact modified, for injection moulding. Thi grade offers excellent chemical resistance, low water absorption, very good mechanical properties and moldability. It is a partially bio-sourced material.&& |
| Product Description | |
|---|---|
| Supplier | DOMO |
| Generic | PA610 |
| Material Status | Commercial: Active |
| Features | High impact resistance,Solvent resistance,Low or no water absorption,Excellent Processability |
| Availabilitys | North America,Africa & Middle East ,Europe,Asia Pacific,Latin America |
| Process Methods | Injection Molding |
| Technical Data |
|---|
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| drying temperature | 80 | °C | |
| Recommended maximum moisture content | 0.20 | % | |
| Temperature at the rear of the barrel | 240 to 250 | °C | |
| Temperature in the middle of the barrel | 245 to 255 | °C | |
| Front temperature of material barrel | 250 to 260 | °C | |
| Mold temperature | 60 to 90 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |