| About |
|---|
| Product Description | |
|---|---|
| Supplier | DOMO |
| Generic | PA 66/6T |
| Material Status | Commercial: Active |
| Features | Good surface appearance,Excellent Processability,Good heat aging resistance,Good liquidity |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.42 | g/cm³ | |
| Shrinkage rate | |||
| TD | 0.76 | % | |
| MD | 0.26 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | |||
| 23℃ | 11100 | MPa | |
| Tensile stress (fracture, 23 ° C) | 203 | MPa | |
| Tensile strain | |||
| Fracture, 23 ℃ | 3.2 | % |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Notched Impact Strength | |||
| -30℃ | 10 | kJ/m² | |
| 23℃ | 13 | kJ/m² | |
| Charpy Unnotch Impact strength | |||
| -30℃ | 66 | kJ/m² | |
| 23℃ | 80 | kJ/m² |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 239 | ℃ | |
| Melting temperature | 270 | ℃ |
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| drying temperature | 80 | °C | |
| Recommended maximum moisture content | 0.12 | % | |
| Temperature at the rear of the barrel | 290 to 300 | °C | |
| Temperature in the middle of the barrel | 295 to 305 | °C | |
| Front temperature of material barrel | 300 to 310 | °C | |
| Mold temperature | 85 to 100 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |