TECHNYL STAR® AFX 216 V50 GREY 2684

About
TECHNYL STAR® AFX 216 V50 Grey 2684 is a high flow polyamide 66 resin, reinforced with 50% of glass fibre, for injection moulding. Due to its outstanding flow caracteristics, this grade shows exceptional processing behaviour and excellent surface aspect of the finished part.&&

Product Description
Supplier	DOMO
Generic	PA66
Material Status	Commercial: Active
Features	Good Rigidity,Good Dimensional Stability,High liquidity,Good surface appearance
Availabilitys	Europe,Africa & Middle East
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.57	g/cm³
Water absorption rate
23℃，24hr	0.60	%
Equilibrium, 23 ℃, 50% RH	1.3	%

MECHANICAL	Nominal value	Unit
Tensile modulus
23℃	17000	MPa
tensile strength
Fracture, 23 ℃	255	MPa
Tensile strain
Fracture, 23 ℃	2.5	%

IMPACT	Nominal value	Unit
Charpy Notched Impact Strength
23℃	15	kJ/m²
Charpy Unnotch Impact strength
23℃	100	kJ/m²

THERMAL	Nominal value	Unit
Hot deformation temperature
1.8 MPa, unannealed	256	℃
Melting temperature	264	℃

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
Flame retardant level
0.80 mm	HB
1.60 mm	HB
3.20 mm	HB

Process Conditions
Injection	Nominal value	Unit	Test method
Injection instructions	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	265 to 275	°C
Temperature in the middle of the barrel	270 to 280	°C
Front temperature of material barrel	280 to 290	°C
Mold temperature	60 to 90	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.