TECHNYL® XA 1570 BLACK

About
TECHNYL® XA 1570 BLACK is a polyamide 66, reinforced with 30% of glass fiber, heat stabilized, for injection moulding. This product contains some high quality recycled polymer made from selected sources of industrial production falls with no Titanium dioxide. The product offers an excellent combination between thermal and mechanical properties. The results shown are based on first industrial lots. These results will be further enhanced and improved as more industrials lots are produced and statistical data are available.&&

About

TECHNYL® XA 1570 BLACK is a polyamide 66, reinforced with 30% of glass fiber, heat stabilized, for injection moulding. This product contains some high quality recycled polymer made from selected sources of industrial production falls with no Titanium dioxide. The product offers an excellent combination between thermal and mechanical properties. The results shown are based on first industrial lots. These results will be further enhanced and improved as more industrials lots are produced and statistical data are available.&&

Product Description
Supplier	DOMO
Generic	PA66
Material Status	Commercial: Active
Features	Good liquidity,Heat Stabilized,Good stripping performance
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.36	g/cm³
Water absorption rate
23℃，24hr	0.91	%

MECHANICAL	Nominal value	Unit
Tensile modulus
23℃	9920	MPa
tensile strength
Fracture, 23 ℃	185	MPa
Tensile strain
Fracture, 23 ℃	2.9	%
Bending modulus
23℃	8700	MPa
bending strength
23℃	275	MPa

IMPACT	Nominal value	Unit
Charpy Notched Impact Strength
-30℃	7.5	kJ/m²
23℃	8.5	kJ/m²
Charpy Unnotch Impact strength
-30℃	56	kJ/m²
23℃	60	kJ/m²
Impact strength of cantilever beam notch
23℃	8.8	kJ/m²
Notched impact strength of cantilever beam
23℃	52	kJ/m²

THERMAL	Nominal value	Unit
Hot deformation temperature
1.8 MPa, unannealed	248	℃
Melting temperature	263	℃

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
0.80 mm	HB

Process Conditions
Injection	Nominal value	Unit	Test method
Injection instructions	Nominal value	Unit	Test method
drying temperature	80	°C
Recommended maximum moisture content	0.20	%
Temperature at the rear of the barrel	270 to 280	°C
Temperature in the middle of the barrel	275 to 285	°C
Front temperature of material barrel	280 to 290	°C
Mold temperature	70 to 100	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.