| About |
|---|
| Tekniflex® ECO series are designed for the blister packaging of Pharmaceutical products requiring good moisture and oxygen barrier. Tekniflex® ECO series are transparent, FDA-compliant, Pharmaceutical Grade PP.COC.EVOH.PP film co-extrusions, which can be easily be thermoformed into blister packs. Tekni-Plex offers a wide range of COC-based film structures to meet both performance and cost requirements.&& |
| Product Description | |
|---|---|
| Generic | PP+COC+EVOH+PP |
| Material Status | Commercial: Active |
| Features | Low odor,Moisture resistance |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Process Methods | Thermo forming |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.970 | g/cm³ | |
| dimensional stability | |||
| 140℃ | -4.0 to 4.0 | % | |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | 260 | µm | |
| tensile strength | |||
| MD, yield | 42.8 | MPa | |
| Oxygen transfer rate | |||
| 23℃，100% RH | 0.50 | cm³/m²/24 hr | |
| Water vapor transmittance | |||
| 38℃，90% RH | 0.45 | g/m²/24 hr | |
| dosage | 3.95 | m²/kg |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Haze | 3.0 | % |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Roll Width | < 110.00 | cm | |
| Temperature of hot forming mold | 100 to 160 | ℃ |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 30 minutes |
| 3. Thickness tolerance: ±10% |
| 4. Roll width tolerance: ±1.5 mm |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |