| About |
|---|
| This data sheet describes TEKNILID 1208 product This lid stock is made with vinyl heat seal (HS) material for Food, Pharmaceutical, and Cosmetic applications requiring a child resistance (CR) seal to PVC, PVDC, and PET along with high oxygen and moisture barrier performance. It is to mechanically defeat the child via the cut/tear feature Open one blister cavity by cutting, tear the Paper/PET/Alum Foil layer to expose the product It is available with custom and standard printing&& |
| Product Description | |
|---|---|
| Generic | 铝箔 |
| Material Status | Commercial: Active |
| Features | Low odor,Food contact compliance,Moisture resistance |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| film | Nominal value | Unit | Test method |
| film thickness | 102 | µm | |
| tensile strength | |||
| MD, yield | 0.230 | MPa | ASTM D882 |
| Sealing emphasis | |||
| — | 0.55 | N/mm | |
| — | 0.67 | N/mm | |
| — | 0.78 | N/mm | |
| Oxygen transfer rate | |||
| 23℃，100% RH | < 0.15 | cm³/m²/24 hr | |
| Water vapor transmittance | |||
| 38℃，90% RH | < 0.15 | g/m²/24 hr | |
| dosage | 7.47 | m²/kg | |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Roll Width | > 2.54 | cm |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Thickness tolerance: ±10% |
| 3. To PVdC @ 350°F, 40psi, 0.5 sec |
| 4. To PVC @ 350°F, 40psi, 0.5 sec |
| 5. To PET @ 350°F, 40psi, 0.5 sec |
| 6. Roll width tolerance: ±1.6 mm |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |