| About |
|---|
| This data sheet describes TEKNILID 1253 product This lid stock is made with heat seal (HS) lacquer material for Food, Pharmaceutical, and Cosmetic applications requiring a welded seal to PVC or PVDC along with high oxygen and moisture barrier performance Aluminum Lidding Foil of 25 µm Soft Temper is used for applications requiring a “push through” feature. You push the product through the foil to access the product. It is available with custom and standard printing&& |
| Product Description | |
|---|---|
| Generic | 铝箔 |
| Material Status | Commercial: Active |
| Features | Low odor,Food contact compliance,Moisture resistance |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| film | Nominal value | Unit | Test method |
| film thickness | 31.1 | µm | |
| tensile strength | |||
| MD, yield | > 150 | MPa | |
| Tensile strain | |||
| MD, fracture | > 1.5 | % | |
| Sealing emphasis | |||
| — | 0.41 | N/mm | |
| — | 0.41 | N/mm | |
| Oxygen transfer rate | |||
| 23℃，100% RH | 0.0 | cm³/m²/24 hr | |
| Water vapor transmittance | |||
| 38℃，90% RH | 0.0 | g/m²/24 hr | |
| dosage | 13.2 | m²/kg | |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Heat resistant temperature | |||
| of the Laquer for Printing | < 220 | ℃ | |
| Melt Temperature | |||
| of the Thermosealable Varnish | 100 | ℃ |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Thickness tolerance: ±10% |
| 3. of Aluminum |
| 4. To PVDC @ 350°F, 40psi, 0.5 sec |
| 5. To PVC @ 350°F, 40psi, 0.5 sec |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |