| About |
|---|
| Telene® 1810 A/B is a Dicyclopentadiene (DCPD) product. It is available in Africa & Middle East, Asia Pacific, Europe, Latin America, or North America. Characteristics include: REACH Compliant RoHS Compliant&& |
| Product Description | |
|---|---|
| Generic | DCPD |
| Material Status | Commercial: Active |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.03 | g/cm³ | ISO 1183 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 1700 | MPa | ISO 527-2 |
| tensile strength | |||
| yield | 44.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| yield | 5.0 | % | ISO 527-2 |
| Bending modulus | 1700 | MPa | ISO 178 |
| bending strength | 61.0 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 30 | kJ/m² | ISO 180 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 120 | ℃ | ISO 75-2/A |
| Glass transition temperature | 169 | ℃ | ASTM D790 |
| Linear coefficient of thermal expansion | |||
| MD | 7.9E-5 | 1/℃ | ISO 11359-2 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Exotherm Temperature | > 180 | ℃ | Internal Method |
| Initial Viscosity（Brookfield，30℃） | 260 | mPa·s | Internal Method |
| Smoke Time（30℃） | 10.0 | min |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Method 4 |
| 3. Method 4 Slower/faster formulation on demand |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |