TEREZ GT2 300 H G50

About
Polyarylamide with 50% glass fiber reinforcement and heat stabilization. For all kind of injection molding parts.&&

Product Description
SupplierTER
GenericParaformaldehyde
Material StatusCommercial: Active
FeaturesGood Rigidity,Heat Stabilized
AvailabilitysEurope
Process MethodsInjection Molding

Technical Data
PHYSICALNominal valueUnitTest method
Density1.64g/cm³
Water absorption rate
Saturation, 23 ℃1.5%
Equilibrium, 23 ℃, 50% RH0.16%

MECHANICALNominal valueUnitTest method
Tensile modulus20000MPa
tensile strength
fracture280MPa
Tensile strain
fracture2.0%

IMPACTNominal valueUnitTest method
Charpy Notched Impact Strength
23℃15kJ/m²
Charpy Unnotch Impact strength
23℃65kJ/m²

THERMALNominal valueUnitTest method
Hot deformation temperature
0.45 MPa, unannealed230
1.8 MPa, unannealed215
Melting temperature237

Electrical performanceNominal valueUnitTest method
Dielectric strength31kV/mm
Compared to the leakage tracing index570V

FLAME CHARACTERISTICSNominal valueUnitTest method
Flammability level
1.6 mmHB 

Notes
1. Typical properties: these are not to be construed as specifications.
2. 10°C/min
【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.