| About |
|---|
| The UV/FG Series is your material solution for applications requiring high UV resistance. It is particularly appropriate for automotive exterior and interior components. Typical applications Cowls gaskets Roof rims Soft touch for grips, switches and mats Water deflectors Window encapsulations Material advantages Easy flowing Excellent mechanical properties Fulfills specifications for automotive interior Perfect adhesion to PP Perfect surface finish Tested according PV3930 for outdoor use&& |
| Product Description | |
|---|---|
| Supplier | KRAIBURG |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good surface appearance,Good liquidity,Good bond |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.980 | g/cm³ | ISO 1183 |
| Spiral flow length | 87.0 | cm | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 7.00 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 800 | % | ISO 37 |
| tear strength | 15 | kN/m | ISO 34-1 |
| Compression deformation | ISO 815 | ||
| 23℃，72 hr | 23 | % | ISO 815 |
| 70℃，24 hr | 44 | % | ISO 815 |
| 100℃，24 hr | 73 | % | ISO 815 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 55 | ISO 7619 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 60 to 80 | °C | |
| Drying time | 2.0 to 4.0 | hr | |
| Barrel rear temperature | 180 | °C | |
| Barrel middle temperature | 200 | °C | |
| Barrel front temperature | 220 | °C | |
| Mold temperature | 25 to 40 | °C | |
| Injection pressure | 20.0 to 100 | MPa | |
| Back pressure | 2.00 to 10.0 | MPa | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Injection Pressure: 1.02E+3 psi |
| 3. Type S2, 7.9 in/min |
| 4. Method Bb, Angle (Nicked) |
| 5. Method A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |