| About |
|---|
| THERMORUN® 3855B/N is a Thermoplastic Elastomer (TPE) material. It is available in Asia Pacific, Europe, or North America for extrusion or injection molding. Primary attribute of THERMORUN® 3855B/N: Low Hardness.&& |
| Product Description | |
|---|---|
| Supplier | Mitsubishi |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Antifreeze,High Heat Resistance,Inoxidizability,Fatigue resistance,Elastic,Good tear strength,Good wear resistance |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.890 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 230℃，5.0kg | 12 | g/10min | ISO 1133 |
| Shrinkage rate | ISO 294-4 | ||
| TD | 1.5 to 2.0 | % | ISO 294-4 |
| MD | 1.5 to 2.0 | % | ISO 294-4 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 80 | ISO 868 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 12.0 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 700 | % | ISO 37 |
| tear strength | 51 | kN/m | ISO 34-1 |
| Compression deformation | |||
| 70℃，22 hr | 47 | % | ISO 815 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |