| About |
|---|
| Thermoset Plastics 310 is an Epoxy; Epoxide (Epoxy) material. It is available in North America for casting or encapsulating. Important attributes of Thermoset Plastics 310 are: Good Toughness Heat Resistant Insulating Rigid Typical application of Thermoset Plastics 310: Wire & Cable&& |
| Product Description | |
|---|---|
| Supplier | Lord |
| Generic | 环氧树脂 |
| Material Status | Commercial: Active |
| Features | Good flexibility,Good thermal shock resistance,Insulation |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.07 | g/cm³ | ASTM D792 |
| Water absorption rate | |||
| 24hr | 0.30 | % | ASTM D570 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 130 | J/m | ASTM D256 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 6.0E+15 | ohms·cm | ASTM D257 |
| Dielectric constant | |||
| 1 MHz | 3.80 | ASTM D150 | |
| Dissipation factor | |||
| 1 MHz | 0.018 | ASTM D150 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Thermosetting components | |||
| resin | 按重量计算的混合比: 1.0 | ||
| Hardening method | 按重量计算的混合比: 1.0 |
| Thermosetting mixed viscosity | Nominal value | Unit | Test method |
|---|---|---|---|
| 25℃ | 2700 | cP | ASTM D2393 |
| stripping time | |||
| 121℃ | 120 | min |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 65 | ASTM D2240 | |
| tensile strength | |||
| yield | 17.2 | MPa | ASTM D638 |
| Tensile strain | |||
| yield | 82 | % | ASTM D638 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |