| About |
|---|
| Thermoset Plastics DC-151 is an Epoxy; Epoxide (Epoxy) material. It is available in North America for laminating. Primary attribute of Thermoset Plastics DC-151: Impact Resistant. Typical application of Thermoset Plastics DC-151: Coating Applications&& |
| Product Description | |
|---|---|
| Supplier | Lord |
| Generic | 环氧树脂 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Weather resistance is good,Low warping,Good surface appearance,High impact resistance,High liquidity,Good Hardness,Quick molding cycle,Food contact compliance |
| Availabilitys | Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Apparent density | 1.19 | g/cm³ | ASTM D1895 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Thermosetting components | |||
| resin | 按重量计算的混合比: 100 按容量计算的混合比: 3.2 | ||
| Hardening method | 按重量计算的混合比: 25 按容量计算的混合比: 1.0 |
| Thermosetting mixed viscosity | Nominal value | Unit | Test method |
|---|---|---|---|
| 25℃ | 2500 | cP | ASTM D2393 |
| stripping time | |||
| 25℃ | 960 to 1400 | min |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 88 | ASTM D2240 | |
| tensile strength | |||
| yield | 179 | MPa | ASTM D638 |
| bending strength | |||
| yield | 241 | MPa | ASTM D790 |
| compressive strength | 279 | MPa | ASTM D695 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |