TITANPRO® PD943

About
Polypropylene homopolymer. The base resin meets the requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520(a)(1)(i) and (c)1.1a. The adjuvant meet their respective FDA regulations and 21 CFR 177.1520(b). In summary, this resin meets the FDA criteria covering safe use of polyolefin articles and component of articles intended for food contact use. TSCA Registry: CAS# 9003-07-0 APPLICATIONS: Bags for hosiery, shirts and other textiles and food packaging for fresh fruits and produce. Characteristics: Good optical properties, excellent stiffness and high slip development and good openability. FABRICATION: Equipment -general water quench blown film machines and techniques – standard processing. Extrusion and water bath conditions can be varied to obtain the desired optical and mechanical film properties.&&

About

Polypropylene homopolymer. The base resin meets the requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520(a)(1)(i) and (c)1.1a. The adjuvant meet their respective FDA regulations and 21 CFR 177.1520(b). In summary, this resin meets the FDA criteria covering safe use of polyolefin articles and component of articles intended for food contact use. TSCA Registry: CAS# 9003-07-0 APPLICATIONS: Bags for hosiery, shirts and other textiles and food packaging for fresh fruits and produce. Characteristics: Good optical properties, excellent stiffness and high slip development and good openability. FABRICATION: Equipment -general water quench blown film machines and techniques – standard processing. Extrusion and water bath conditions can be varied to obtain the desired optical and mechanical film properties.&&

Product Description
Supplier	LOTTE
Generic	PP homopolymerization
Material Status	Commercial: Active
Features	Good Rigidity,Optical performance,Food contact compliance,Homopolymer
Availabilitys	Asia Pacific

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ASTM D1505
Melt Flow Rate
230℃，2.16kg	11	g/10min	ASTM D1238
Water absorption rate
24hr	0.020	%	ASTM D570

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	32	J/m	ASTM D256-A

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	95.0	℃	ASTM D648

MECHANICAL	Nominal value	Unit	Test method
Rockwell hardness
R-level	94		ASTM D785
tensile strength
yield	35.3	MPa	ASTM D638
Tensile strain
yield	12	%	ASTM D638
Bending modulus	1670	MPa	ASTM D790B

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.