TITANPRO® PX617

About
Polypropylene homopolymer. The base resin meets the requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520(a)(1)(i) and (c)1.1a. The adjuvant meet their respective FDA regulations and 21 CFR 177.1520(b). In summary, this resin meets the FDA criteria covering safe use of polyolefin articles and component of articles intended for food contact use. TSCA Registry: CAS# 9003-07-0 APPLICATIONS: Sheet for thermoforming and sheet for stationery files, etc. Characteristics: Outstanding processability with high production rate, good optical properties, good melt stability, low taste and odor, no plate-out problems on die lips or chill rolls and good heat-aging stability. FABRICATION: Equipment – sheet extrusion and thermoforming machines and techniques – standard processing for sheet.&&

About

Polypropylene homopolymer. The base resin meets the requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520(a)(1)(i) and (c)1.1a. The adjuvant meet their respective FDA regulations and 21 CFR 177.1520(b). In summary, this resin meets the FDA criteria covering safe use of polyolefin articles and component of articles intended for food contact use. TSCA Registry: CAS# 9003-07-0 APPLICATIONS: Sheet for thermoforming and sheet for stationery files, etc. Characteristics: Outstanding processability with high production rate, good optical properties, good melt stability, low taste and odor, no plate-out problems on die lips or chill rolls and good heat-aging stability. FABRICATION: Equipment – sheet extrusion and thermoforming machines and techniques – standard processing for sheet.&&

Product Description
Supplier	LOTTE
Generic	PP homopolymerization
Material Status	Commercial: Active
Features	Excellent Processability,Good heat aging resistance,Optical performance,Quick molding cycle,Food contact compliance,Low odor,Homopolymer,Higher melt stability
Availabilitys	Asia Pacific

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.900	g/cm³	ASTM D1505
Melt Flow Rate
230℃，2.16kg	1.7	g/10min	ASTM D1238
Water absorption rate
24hr	0.020	%	ASTM D570

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	59	J/m	ASTM D256-A

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	102	℃	ASTM D648

MECHANICAL	Nominal value	Unit	Test method
Rockwell hardness
R-level	88		ASTM D785
tensile strength
yield	34.3	MPa	ASTM D638
Tensile strain
yield	9.0	%	ASTM D638
Bending modulus	1620	MPa	ASTM D790B

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.