| About |
|---|
| Toraypef® 15020 AP8M is a Polyolefin product. It can be processed by compression molding or foam processing and is available in Asia Pacific, Europe, or North America. Typical application: Foam. Primary characteristic: heat resistant.&& |
| Product Description | |
|---|---|
| Supplier | Toray |
| Generic | 聚烯烃，共挤薄膜用聚烯烃 |
| Material Status | Commercial: Active |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Foam treatment |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.0670 | g/cm³ | |
| Thickness | 2.00 | mm | |
| Shrinkage rate | |||
| MD：120℃ | -2.0 | % | |
| TD：120℃ | -1.4 | % | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| TD, yield | 1.40 | MPa | |
| MD, yield | 1.70 | MPa | |
| tear strength | |||
| TD | 9.20 | kN/m | |
| MD | 7.70 | kN/m |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Gel Fraction | 52 | % | |
| Thermoforming Ratio（H/D） | 0.580 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Compression hardness | |||
| 25% | 0.169 | MPa | |
| Tensile strain | |||
| MD | 240 | % | |
| TD | 240 | % |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Foamed |
| 3. 60 min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |