| About |
|---|
| HDPE 2008 SN 60 is a high density polyethylene (HDPE) with very high stiffness and low viscosity. It has been specifically designed for the manufacture of thin walled containers for foodstuffs. HDPE 2008 SN 60 is a pellet grade and contains antioxidants.&& |
| Product Description | |
|---|---|
| Supplier | TOTAL |
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Low Viscosity,Inoxidizability,High density |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.951 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 200℃，5.0kg | 20 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 3.2mm | 32 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 76.1 | ℃ | ASTM D648 |
| Vicat Softening Temp | 121 | ℃ | ASTM D1525 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 65 | ASTM D2240 | |
| tensile strength | 26.9 | MPa | ASTM D638 |
| Bending modulus | 1280 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |