| About |
|---|
| Polyethylene Lumicene® mPE M 3410 EP: Outstanding clarity and gloss; excellent bubble stability; high stiffness; good tear strength; good puncture resistance; good heat sealing properties; excellent compatibility with LDPE and LLDPE. Applications: Lumicene® mPE M 3410 EP is recommended for tissue & towel overwrap films, clarity shrink films, protective packaging, laminations and multilayer packaging films.&& |
| Product Description | |
|---|---|
| Supplier | TOTAL |
| Generic | MDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good Clarity,Good surface appearance,Good heat sealing,Good tear strength,Puncture Resistant |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.934 | g/cm³ | ASTM D792 |
| Melt Flow Rate | ASTM D1238 | ||
| 190℃，2.16kg | 0.90 | g/10min | ASTM D1238 |
| 190℃，21.6kg | 30 | g/10min | ASTM D1238 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| film thickness | |||
| test | 25 | µm | |
| Secant modulus | |||
| 1% secant, TD, 25 µ m, blow molded film | 386 | MPa | ASTM D882A |
| 1% secant, MD, 25 µ m, blow molded film | 365 | MPa | ASTM D882A |
| tensile strength | |||
| TD, fracture, 25 µ m, blow molded film | 42.1 | MPa | ASTM D882A |
| MD, fracture, 25 µ m, blow molded film | 44.1 | MPa | ASTM D882A |
| Tensile strain | |||
| TD, fracture, 25 µ m, blow molded film | 650 | % | ASTM D882A |
| MD, fracture, 25 µ m, blow molded film | 400 | % | ASTM D882A |
| Drop hammer impact | |||
| 25 µ m, blow molded film | 60 | g | ASTM D1709-A |
| tear strength | |||
| TD, 25 µ m, blow molded film | 400 | g | ASTM D1922 |
| MD, 25 µ m, blow molded film | 55 | g | ASTM D1922 |
| Water vapor transmittance | |||
| 25 µ m, blow molded film | 10 | g/m²/24 hr | ASTM F1249 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting peak temperature | 124 | ℃ | ASTM D3417 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Melt temperature | 193 to 210 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |