| About |
|---|
| NE Series – TPV Elastoprene® It is a mixture of polypropylene and dynamically vulcanised EPDM rubber (PP/EPDM), with properties similar to those of other rubber products but with better results than traditional plastic materials. It has good resistance to the effects of ozone, UV rays and diverse chemical products, with an operating temperature of up to 135°C. It comes in pellet form, and it is transformed by means of traditional machinery used for plastic. It is a completely recyclable and reusable material. Recommended for extrusion and co-extrusion transformation processes&& |
| Product Description | |
|---|---|
| Generic | PP+EPDM |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Renewable resources,Ozone resistance,Solvent resistance |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.960 | g/cm³ | ISO 1183/A |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 5 seconds, 6.00 mm, extruded | 73 | ISO 868 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, 2 mm | 7.00 | MPa | ISO 37 |
| 100% strain, 2 mm | 3.00 | MPa | ISO 37 |
| Tensile strain | |||
| Fracture, 2 mm | 350 | % | ISO 37 |
| tear strength | |||
| 23℃，2.00 mm | 9.0 | kN/m | ISO 34-1 |
| Compression deformation | |||
| 70℃，22 hr | 38 | % | ISO 815 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -58.0 | ℃ | ISO 812 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 2.00 mm | HB | UL 94 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Ozone resistance | 0 Rating | ISO 1431-1 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Drying temperature | 80 | °C | |
| Melt temperature | 170 to 200 | °C | |
| Nozzle temperature | 200 to 220 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 20 in/min |
| 3. Method A, Trouser |
| 4. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |