| About |
|---|
| TRIEL® 5501BM is a Thermoplastic Polyester Elastomer (TPEE) product. It is available in Asia Pacific, Europe, or North America.&& |
| Product Description | |
|---|---|
| Supplier | Samyang |
| Generic | TPEE |
| Material Status | Commercial: Active |
| Availabilitys | North America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.22 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 0.50 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 1.7 to 2.0 | % | ASTM D955 |
| Water absorption rate | |||
| 23℃，24hr | 0.50 | % | ASTM D570 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 50 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| fracture | 26.5 | MPa | ASTM D638 |
| 5% strain | 3.92 | MPa | ASTM D638 |
| 10% strain | 7.85 | MPa | ASTM D638 |
| 50% strain | 12.7 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | > 400 | % | ASTM D638 |
| Bending modulus | 118 | MPa | ASTM D790 |
| bending strength | |||
| yield | 6.86 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ASTM D256 | ||
| -40℃ | No Break | ASTM D256 | |
| 23℃ | No Break | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 0.45 MPa, unannealed | 86.0 | ℃ | ASTM D648 |
| Vicat Softening Temp | 174 | ℃ | ASTM D1525 2 |
| Melting temperature | 210 | ℃ | ASTM D2117 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Rate B (120°C/h), Loading 1 (10 N) |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |