Tuftec™ P1500

About
Asahi Kasei Tuftec™ P1500 is a selectively hydrogenated polymer. It is good as a base polymer for pressure sensitive adhesives (PSA). It has excellent compatibility with a variety of tackifiers. With blending tackifier and white oil, it provides solvent-borne as well as hot-melt adhesives. It is particularly suitable for hot-melt adhesive with low viscosity and good thermal stability. Applications: Primarily for low-viscosity hot-melt adhesives, e.g. hot-melt adhesives for sanitary goods. Superior to SBS in thermal stability. Reduced viscosity variance and discoloration. Compatible with full range of tackifiers, enabling broader range and freedom in selection of co-components and formulations than SBS or SEBS.&&

About

Asahi Kasei Tuftec™ P1500 is a selectively hydrogenated polymer. It is good as a base polymer for pressure sensitive adhesives (PSA). It has excellent compatibility with a variety of tackifiers. With blending tackifier and white oil, it provides solvent-borne as well as hot-melt adhesives. It is particularly suitable for hot-melt adhesive with low viscosity and good thermal stability. Applications: Primarily for low-viscosity hot-melt adhesives, e.g. hot-melt adhesives for sanitary goods. Superior to SBS in thermal stability. Reduced viscosity variance and discoloration. Compatible with full range of tackifiers, enabling broader range and freedom in selection of co-components and formulations than SBS or SEBS.&&

Product Description
Supplier	Asahi Kasei
Generic	SEBS
Material Status	Commercial: Active
Features	Low Viscosity,Heat Stabilized
Availabilitys	Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.910	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	4.0	g/10min	ISO 1133
viscosity
15% toluene solution	35.0		ISO 7619

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	69		ISO 7619

elastic body	Nominal value	Unit	Test method
tensile strength
fracture	3.30	MPa	ISO 37
300% strain	2.10	MPa	ISO 37
Tensile strain
fracture	780	%	ISO 37

Supplementary information	Nominal value	Unit	Test method
Styrene/Rubber ratio	30/70		Internal Method

Notes
1. Typical properties: these are not to be construed as specifications.
2. Type 1A, 20 in/min
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.