TyrFil® R-2 - SOLIAO

About
TyrFil® R-2 is a two-component system consisting of Catalyst blend (side A) and Prepolymer (side B). It is designed to be used as a binder for ground rubber for filling tires. Total amount of filler is up to 35% by weight in cured material.&&

Product Description
Generic	PUR+MDI
Material Status	Commercial: Active
Availabilitys	North America

Technical Data
MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	36 to 40		ASTM D2240
Shaw’s A	23 to 27		ASTM D2240

elastic body	Nominal value	Unit
tensile strength
fracture	1.20	MPa
Tensile strain
fracture	300	%
tear strength
—	6.80	kN/m
cracking	0.70	kN/m
Basho’s elasticity	30 to 45	%

THERMAL	Nominal value	Unit	Test method
Storage period	52	wk

Thermosetting mixed viscosity	Nominal value	Unit
25℃	250 to 300	cP
25℃	250 to 350	cP
Gelation time	20.0 to 25.0	min

PHYSICAL	Nominal value	Unit
Melt density
25℃	1.08	g/cm³
25℃	1.05	g/cm³

Supplementary information	Nominal value	Unit
Curing time
25℃	1.0	day
Mixing ratio
—	100:101
—	1:1
Processing temperature	21 to 27	℃
memo_intro

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.